Remote control mode setup, 2 select the remote control mode setting you want, 3 select “ok” to change the remote control mode – Pioneer VSX-920-K User Manual
Page 107: 5 when you’re finished, press return, Flicker reduction setup, 2 select the flicker reduction setting you want, 3 when you’re finished, press return, The system setup and other setup menus 11
The System Setup and Other Setup menus
11
107
En
English
Français
Deutsch
Nederlands
Italiano
Español
Remote Control Mode Setup
• Default setting:
1
This sets this receiver’s remote control mode to
prevent erroneous operation when multiple
units of the receiver are being used.
1
1
Select ‘Remote Control Mode Setup’
from the Other Setup menu.
2
Select the Remote Control Mode setting
you want.
3
Select “OK” to change the remote control
mode.
4
Follow the instructions on the screen to
change the remote control’s setting.
See Operating multiple receivers on page 77.
5
When you’re finished, press RETURN.
You will return to the
Other Setup menu.
Flicker Reduction Setup
• Default setting:
OFF
The GUI screen’s resolution can be increased.
If you feel the GUI screen is hard to see, try
changing this setting. Note this setting only
affects the GUI screen; it has no influence on
the video output.
1
Select ‘Flicker Reduction Setup’ from the
Other Setup menu.
2
Select the Flicker Reduction setting you
want.
3
When you’re finished, press RETURN.
You will return to the
Other Setup menu.
Note
1 If you change this receiver’s setting, also change the setting on the remote control.
VSX-1020_SYXCN.book 107 ページ ２０１０年３月１２日 金曜日 午前９時１０分