Pioneer VSX-920-K - Manual (Page 71)

Using other functions 08
71
En
English
Français
Deutsch
Nederlands
Italiano
Español
Setting the Video options
There are a number of additional picture
settings you can make using the
VIDEO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• Note that if an option cannot be selected
on the VIDEO PARAMETER menu, it is
unavailable due to the current source,
setting and status of the receiver.
1 Press , then press VIDEO
PARAMETER.
2 Use
/ to select the setting you want
to adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on
this.
3 Use / to set as necessary.
See the table below for the options available
for each setting.
1
4 Press RETURN to confirm and exit the
menu.
i. This feature is only available when the connected display supports the automatic audio/video synchronizing capability
(‘lipsync’) for HDMI. If you find the automatically set delay time unsuitable, set A. DELAY to OFF and adjust the delay
time manually. For more details about the lipsync feature of your display, contact the manufacturer directly.
j. Only when listening to 2-channel sources in Dolby Pro Logic IIx Music/Dolby Pro Logic II Music mode.
k.Only when listening to 2-channel sources in Neo:6 MUSIC/CINEMA mode.
l. • You can’t use the Virtual Surround Back mode when the headphones are connected to this receiver or when any of
the stereo, Front Stage Surround Advance or Stream Direct modes is selected.
• You can only use the Virtual Surround Back mode if the surround speakers are on and the
SB setting is set to NO
or if Front Bi-Amp or ZONE 2 is selected at Speaker System.
• The Virtual Surround Back mode cannot be applied to sources that do not have surround channel information (only
when listening in some formats of Dolby TrueHD, DTS-HD or DTS Express mode).
m.• You can’t use the Virtual Front Height mode when the headphones are connected to this receiver or when any of
the stereo, Front Stage Surround Advance or Stream Direct modes is selected.
• You can only use the Virtual Front Height mode if the surround speakers are on.
• The Virtual Front Height mode cannot be applied to sources that do not have surround channel information (only
when listening in some formats of Dolby TrueHD, DTS-HD or DTS Express mode).
Note
1 • All of the setting items can be set for each input function.
• Setting items other than V. CONV can only be selected when V. CONV is set to ON.
RECEIVER
Setting What it does Option(s)
V. CONV a
(Digital Video Conversion)
Converts video signals for output from the MONITOR OUT jacks
(including HDMI OUT connector) for all video types (see page 24).
ON
OFF
RES b (Resolution) Specifies the output resolution of the video signal (when video
input signals are output at the
HDMI OUT connector, select this
according to the resolution of your monitor and the images you
wish to watch).
AUTO
PURE
480p/576p
720p
1080i
1080p
VSX-1020_SYXCN.book 71 ページ ２０１０年３月１２日 金曜日 午前９時１０分