Pioneer AVIC-S1 - Manual (Page 105)

User's manual AVIC-S1
Configuring AVIC-S1 - 103 -
Warning in built-up
areas
The amount by which you exceed the speed limit in built-up
areas before the warning is sounded can be changed using the
two "-" and "+"buttons.
Ù Tap on the "+" button to increase the value.
Ù Tap on the "-" button to reduce the value or set it to never.
Warning outside
built-up areas
The amount by which you exceed the speed limit outside of built-
up areas before the warning is sounded can be changed using the
two "-" and "+" buttons.
Ù Tap on the "+" button to increase the value.
Ù Tap on the "-" button to reduce the value or set it to never.
Tap on the Back button in order to close the S PEED L IMIT
W ARNING window.
Attention: the information in the map material can be incorrect
on account of sudden changes (construction sites etc.)!
The traffic situation and the current signposts have priority over
the information given by the navigation system.
8.9 Background
Background In the B ACKGROUND settings window you can select a different
graphic that you can use as a background graphic for your
software.
The current setting is shown on the button.
1. Tap on the button in order to open the B
ACKGROUND
window.
2. Tap on the graphic (skin) that you would like to use as a
background.
The B
ACKGROUND window closes. The new background graphic
can now be used.
Repeat the process if you are not happy with your choice and
wish to try out a different graphic.
8.10 Autozoom
Autozoom This setting only affects the map when it is in the Standard map
view, and if the map is shown in 2D.
With this setting you can establish whether during a navigation
with 2D display should have a high autozoom, standard
autozoom or low autozoom.
Autozoom means that the zoom intensity changes depending on
your speed: if you drive slowly, the scale reduces. Drive quicker
and the scale increases.
The more intense the autozoom, the smaller the map's scale.
The current setting is shown on the button. Tap on the button to
change the setting.