Pioneer DVH-P5000UB - Manual (Page 20)

Storing and recalling broadcast
frequencies
If you press any of the preset tuning buttons 1
to 6 you can easily store up to six broadcast
frequencies for later recall with the touch of a
button.
! Only the remote control can operate this
function.
! Six stations for each band can be stored in
memory.
% When you find a frequency that you
want to store in memory, press one of pre-
set tuning buttons 1 to 6 and hold until the
preset number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected radio station frequency has been
stored in memory.
The next time you press the same preset tun-
ing button the radio station frequency is re-
called from memory.
# You can also recall radio station frequencies
assigned to preset tuning numbers by pushing
MULTI-CONTROL up or down during the fre-
quency display.
Switching the RDS display
% Press DISPLAY repeatedly to switch be-
tween the following settings:
Program service name
—PTY information—
Frequency
PTY (program type ID code) information is
listed on page 23.
# PTY information and the frequency appear on
the display for eight seconds.
# If a PTY code of zero is received from a station
or the signal is too weak for this unit to pick up
the PTY code, you cannot switch to PTY informa-
tion display.
Receiving PTY alarm broadcasts
When the emergency PTY code broadcasts,
the unit receives it automatically (
ALARM ap-
pears). When the broadcasting ends, the sys-
tem returns to the previous source.
! An emergency announcement can be can-
celed by pressing TA.
Introduction to advanced
operations
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select
FUNCTION.
Turn to change the menu option. Press to se-
lect.
The function menu is displayed.
3 Turn MULTI-CONTROL to select the
function.
BSM (best stations memory)
—REGIONAL (re-
gional)
—LOCAL (local seek tuning)—PTY
(program type selection)
—TRAFFIC (traffic an-
nouncement standby)
—AF (alternative fre-
quencies search)
—NEWS (news program
interruption)
# You can also select the function by pressing
FUNCTION on the remote control.
# If MW/LW band is selected, you can only se-
lect
BSM or LOCAL.
# If you do not operate functions within about
30 seconds, the display automatically returns to
the ordinary display.
# To return to the ordinary display, press BAND.
Storing the strongest broadcast
frequencies
BSM (best stations memory) lets you automa-
tically store the six strongest broadcast fre-
quencies.
Operating this unit
En
20
Section
02