Pioneer DVH-P5000UB - Manual (Page 52)

Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn
MULTI-CONTROL to switch between the
functions in the following order.
CLOCK (clock)
—OFF CLOCK (off clock)—
FM STEP (FM tuning step)
—AUTO PI (auto PI
seek)
—WARNING (warning tone)—AUX1
(auxiliary input1)
—AUX2 (auxiliary input2)—
VIDEO IN (AV input setting)
—CAMERA (rear
view camera setting)
—REAR SP (rear output
and subwoofer controller)
—EVERSCROLL
(ever scroll)
—TV SIGNAL (TV signal setting)—
D.ATT (digital attenuation)
—AUDIO RESET
(audio reset)
Use the following instructions to operate each
particular setting.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND.
# When you select CAMERA (rear view camera)
in
VIDEO IN, you can select CAMERA (rear view
camera setting).
# When the multi-channel processor (e.g., DEQ-
P6600) is connected to this unit, you can operate
D.ATT and AUDIO RESET instead of REAR SP.
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select CLOCK.
Refer to Adjusting initial settings on this page.
2 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing
MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour
—Minute
As you select segments of the clock display,
the selected segment blinks.
3 Push MULTI-CONTROL up or down to
put a clock right.
Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL.
! If 00 to 29, the minutes are rounded down.
(e.g., 10:18 becomes 10:00.)
! If 30 to 59, the minutes are rounded up. (e.g.,
10:36 becomes 11:00.)
Turning the off clock display on
or off
If the off clock display is turned on, the clock
appears on the display when the sources are
off.
1 Use MULTI-CONTROL to select
OFF CLOCK.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to turn the off
clock display on.
# To turn the off clock display off, press
MULTI-CONTROL again.
Operating this unit
En
52
Section
02