Pioneer DVH-P5000UB - Manual (Page 71)

2 Use MULTI-CONTROL to select SLA.
Refer to Introduction of DSP adjustments on
page 67.
3 Push MULTI-CONTROL up or down to
adjust the source volume.
Each time
MULTI-CONTROL is pushed up or
down, source volume increases or decreases.
+4 to
–4 is displayed as the source volume is
increased or decreased.
Notes
! The MW/LW volume level can also be adjusted
with source level adjustments.
! Video CD, CD, compressed audio and DivX
are set to the same source level adjustment
volume automatically.
! External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on this page).
You can turn the auto-equalizer on or off.
1 Use MULTI-CONTROL to select
AUTO EQ.
Refer to Introduction of DSP adjustments on
page 67.
# If auto TA and EQ have not been carried out,
SET AUTO EQ is displayed when AUTO EQ is se-
lected.
2 Push MULTI-CONTROL up to turn the
auto-equalizer on.
ON appears in the display.
# To turn auto-equalizer off, push
MULTI-CONTROL down.
Auto TA and EQ (auto-time
alignment and auto-equalizing)
The auto-time alignment is automatically ad-
justed for the distance between each speaker
and the listening position.
The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.
WARNING
To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.
CAUTION
! Carrying out auto TA and EQ under the follow-
ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
— When speakers are incorrectly connected.
(e.g., When a rear speaker is connected to
a subwoofer output.)
— When a speaker is connected to a power
amp delivering output higher than the
speaker
’s maximum input power capabil-
ity.
! If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in a drain on battery power. Be sure
to place the microphone in the specified loca-
tion.
Available accessories
En
71
Section
03
A
vailable
accessories