Pioneer DVH-P5000UB - Manual (Page 55)

Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
FULL) or subwoofer (SUB W)
connection. If you switch the rear output set-
ting to
SUB W, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
! When the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you
cannot operate this function.
1 Use MULTI-CONTROL to select REAR SP.
Refer to Adjusting initial settings on page 52.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween FULL (full-range speaker) and SUB W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select
SUB W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
45).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVERSCROLL.
Refer to Adjusting initial settings on page 52.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! About your country TV signal, consult with
your nearest Pioneer dealer.
1 Use MULTI-CONTROL to select
TV SIGNAL.
Refer to Adjusting initial settings on page 52.
2 Press MULTI-CONTROL to select an ap-
propriate TV signal.
PAL
—SECAM
Correcting distorted sound
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
1 Use MULTI-CONTROL to select D.ATT.
Refer to Adjusting initial settings on page 52.
Operating this unit
En
55
Section
02
Operating
this
unit