Pioneer DVH-P5000UB - Manual (Page 82)

USB audio player/USB memory
Message Cause Action
CHECK USB The USB connector or USB cable is
short-circuited. Confirm that the USB connector or USB
cable is not caught in something or da-
maged.
The connected USB portable audio
player/USB memory consumes
more than 500 mA (maximum allow-
able current). Disconnect the USB portable audio player/
USB memory and do not use it. Turn the igni-
tion switch to OFF, then to ACC or ON and
then connect the compliant USB portable
audio player/USB memory.
N/A USB The USB device connected to is not
supported by this unit. Connect a USB portable audio player or USB
memory that is USB Mass Storage Class
compliant.
NO AUDIO No songs Transfer the audio files to the USB portable
audio player/USB memory and connect.
USB memory with security enabled
is connected Follow the USB memory instructions to dis-
able the security.
PROTECT All the files on the connected USB
portable audio player/USB memory
are protected by Windows Media
DRM 9/10 Transfer audio files not protected by Windows
Media DRM 9/10 to the USB portable audio
player/USB memory and connect.
SKIPPED The connected USB portable audio
player/USB memory contains WMA
files that are protected by Windows
Media DRM 9/10 Play an audio file not protected by Windows
Media DRM 9/10.
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message Cause Action
ERROR MIC Microphone is not connected. Plug the supplied microphone securely into
the jack.
ERROR FRONT SP, ERROR
FRONT-L SP, ERROR FRONT-R
SP, ERROR CENTER SP, ERROR
REAR SP, ERROR REAR-L SP,
ERROR REAR-R SP, ERROR SUB
WOOFER The microphone cannot pick up the
measuring tone of a speaker.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
Additional Information
En
82
Appendix