B&K p/n 12698 - Manual (Page 15)

SURROUND OUTPUT CONNECTIONS
Connect the A/V System Controller’s surround outputs to your external amplifier(s) or powered speakers.
Here is a typical A/V System Controller output setup :
S U B 1 C E N T E R 1 R E A R L F R O N T L
S U B 2 C E N T E R 2 R E A R R F R O N T R
S U R R O U N D O U T P U T S
P O W E R E D
S U B W O O F E R
Rear Left Rear Right Center Front Right Front Left
P L U S
O U T P U T 3 O U T P U T 1 O U T P U T 2
M I N U S
  
P L U S M I N U S
  
P L U S M I N U S
  
O U T P U T 4
P L U S M I N U S
  
O U T P U T 5
P L U S M I N U S
  
INPUT 2 INPUT 5 INPUT 3 INPUT 1 INPUT 4
Power Amplifier
Subwoofer Output - Connect an RCA cable from one of the A/V System Controller’s two SUB outputs (part of
the surround outputs). You may connect a second subwoofer to the other SUB output if desired. If your subwoofer
does not contain its own amplifier you will need to purchase an external B&K or other power amplifier. Connect the
A/V System Controller’s SUB output to the audio input of the external amplifier. Connect the external amplifier’s
speaker output to your subwoofer.
13
p/n 12698 Rev. 9808B