B&K p/n 12698 - Manual (Page 46)

CONTROL OUT SETUP
Your A/V System Controller’s control outputs allow you to control up to 4 external devices such as power
amplifiers, projection screens, etc. The control outputs can be programmed on/off depending on which source is
selected. They may also have global control for all sources for headphone listening or remote repeater functions.
Control Out 1 - Control out 1 is dedicated to zone 1 it can be programmed to be on or off for each source. For
example you may wish to use the control out to pull down a projection screen for your V1 and DVD sources but roll
it up for Tuner and CD. Control out 1 can also be set to HEADPHONE mode. HEADPHONE mode is intended to
control external amplifiers to permit headphone listening without the need for manually turning off your external
amplifiers. HEADPHONE is a global setting for all sources - if you set HEADPHONE for one source it will be set
for all other sources.
CONTROL OUT SETUP for DVD
'9' & 3+21(6
move to new line
previous page
↑ ↓
M E N U
2 Control Out 2 Zone 2
&21752/ 287
adjust parameter
←→
A U D to select control
1 Control Out 1 Phones
3 Control Out 3 Z1+Z2
4 Control Out 4 Remote
Using AV system controller
select a source to setup
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
move to new line
previous page
↑ ↓
M E N U
select menu page SEL
4 Security Options
3 Control Out
set control out 1 for other sources repeat 4 - 6 repeat 4 - 6 7
set desired control out VOLUME KNOB
ˆ
(REW) or
‡
(FF) 6
return control to A/V System Controller AUDIO 5
select source for Control Out setup
U
(SOURCE) step to source desired source 4
move to Control Out 1 ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 3
activate CONTROL OUT SETUP ↵
(ENTER) SEL or ENTER 2
move to Control Out
∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
44
p/n 12698 Rev. 9808B