B&K p/n 12698 - Manual (Page 47)

Control Out 2, 3, and 4 - Control out 2, 3, and 4 can be used in either zone. For each source they can be
programmed to be on when that source is selected in zone 1, zone 2, or both zones. If the source is selected in
neither zone the control out will be off. Control outs 2, 3, and 4 can also be set to REMOTE. In REMOTE mode
your A/V System Controller acts like a remote repeater - IR remote signals detected by your A/V System Controller
are repeated on the control out. REMOTE mode is a global override for all sources.
'9' & =21( 
CONTROL OUT SETUP for DVD
move to new line
previous page
↑ ↓
M E N U
2 Control Out 2 Zone 2
adjust parameter
←→
A U D to select control
1 Control Out 1 Phones
3 Control Out 3 Z1+Z2
4 Control Out 4 Remote
Using AV system controller
select a source to setup
return to normal operation MENU MENU 10
return to MAIN MENU MENU MENU 9
return to SETUP MENUS MENU MENU 8
return to ADVANCED SYSTEM SETUP MENU MENU 7
set control out 3 and 4 repeat 1 - 5 repeat 1 - 5 6
set control out 2 for other sources repeat 2 - 4 repeat 2 - 4 5
set desired control out VOLUME KNOB
ˆ
(REW) or
‡
(FF) 4
return control to A/V System Controller AUDIO 3
select source for Control Out setup
U
(SOURCE) step to source desired source 2
move to Control Out 2 ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
FACTORY RESET
Should you ever need to completely reset the A/V System Controller to the original factory settings from the front
panel press the SLEEP, DOWN, and LEVEL buttons simultaneously. The A/V System Controller will perform a
complete reset and erase all user programmed presets and menus.
45
p/n 12698 Rev. 9808B