Zone configuration – B&K p/n 12698 User Manual
Page 42
ZONE CONFIGURATION
Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can’t handle the maximum power output from your A/V System Controller or if you simply wish
to limit the volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the A/V System Controller may appear broken (no sound).
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
= 0$; /9/
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
=21( 6(783
move to new line
previous page
↑ ↓
M E N U
select menu page
SEL
3 Control Out
4 Security Options
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter
←→
set desired maximum level
VOLUME KNOB
(REW) or
(FF)
4
move to Z1 Max Level
∧
(UP) or
∨
(DOWN)
(PAUSE) or
V
(STOP)
3
activate ADVANCED ZONE SETTINGS
↵
(ENTER)
SEL or ENTER
2
move to Zone Configuration
∧
(UP) or
∨
(DOWN)
(PAUSE) or
V
(STOP)
1
Action
From Front Panel
From Remote
40
p/n 12698 Rev. 9808B