B&K p/n 12698 - Manual (Page 44)

Z2 Level Control - You may wish to install an in-wall volume control in your second zone. This can cause
confusion between your A/V System Controller’s internal zone 2 volume controls and your in-wall controls. You
can set your A/V System Controller to provide a fixed level to zone 2 instead of the variable level. The fixed level
can be used to limit the maximum volume in zone 2 but setting lower volumes must be done with the in-wall
controls.
WARNING - Setting Z2 LEVEL CONTROL to FIXED will cause your A/V System Controller to immediately
send its maximum zone 2 volume to your second zone (if zone 2 is on). Turn down your in-wall volume
controls before making this change.
= /(9(/ 9$5,
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter
←→
set desired Z2 Level Control VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to Z2 Level Control ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
Z2 Max (Fixed) Level - Z2 max level allows you to set a maximum volume level for zone 2. This is very useful if
you are using speakers that can’t handle the maximum power output from your external amplifier or if you simply
wish to limit the volume that can be achieved using normal front panel or remote operation. If you have chosen
zone 2 fixed level above then this setting becomes the fixed level for zone 2.
WARNING - If you set this level too low, the A/V System Controller may appear broken (no sound).
= 0$; /9/  = ),; /9/ 
or
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter ←→
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Fixed Level +15 dB
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter ←→
return to ADVANCED SYSTEM SETUP MENU MENU 3
set desired Max (Fixed) Level VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to Z2 Max (Fixed) Level ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
42
p/n 12698 Rev. 9808B