B&K p/n 12698 User Manual
Page 35
ADJUSTING THE VOLUME
92/80( '%
Master Volume 0 dB
M A S T E R L E V E L
M A S T E R L E V E L
instant volume all the way down
press MUTE again to restore
can’t do from front panel
MUTE
adjust volume
VOLUME KNOB
VOL
∧
or VOL
∨
Action
From Front Panel
From Remote
Note: The front panel VOLUME KNOB is used to control multiple functions and, therefore, cannot always control
the volume. MASTER LEVEL will light to let you know when the VOLUME KNOB will control volume. The
VOLUME KNOB never controls volume in the menu system. During normal operation the VOLUME KNOB may
switch to controlling other functions but will return to MASTER LEVEL after a few seconds. The remote’s VOL
∧
or
VOL
∨
will always change master volume level except in the SPEAKER CALIBRATION and SOURCE LEVEL
menus.
TEMPORARY LEVEL ADJUSTMENTS
Occasionally you may find that a you can’t hear the dialog very well in a particular movie, or a movie has too much
bass, etc. You can temporarily adjust the center, rear, and subwoofer settings without changing the permanent
settings you made in the SPEAKER CALIBRATION setup.
&(17(5 '%
Center Volume 0 dB
C E N T E R L E V E L
C E N T E R L E V E L
adjust balance Note: only in STEREO
mode
can’t adjust from front panel
(REW) or
(FF)
adjust rear delay
can’t adjust from front panel
DELAY
or DELAY
adjust subwoofer volume
∠
(LEVEL) step to SUB LEVEL
then use VOLUME KNOB
SUB
or SUB
adjust rear volume
∠
(LEVEL) step to REAR LEVEL
then use VOLUME KNOB
REAR
or REAR
adjust center volume
∠
(LEVEL) step to CENTER LEVEL
then use VOLUME KNOB
CENTER
or CENTER
Action
From Front Panel
From Remote
Note: your A/V System Controller remembers a set of temporary adjustments for each source. If, for some reason,
you wanted to adjust CENTER LEVEL for all sources you would need to select each source and adjust it
individually. Also note that these settings are temporary and will be lost when you put your A/V System Controller
to sleep or turn off the main power.
33
p/n 12698 Rev. 9808B