Baracoda Bluetooth Headset - Manual (Page 28)

BaracodaManager for PC – User Guide v3.39 - 28 -
Data Capture
for Workforce
in Motion
8.2. Product settings
To find out more about the product settings, please refer to the barcode reader User Manual.
8.3. Bluetooth settings
To find out more about the Bluetooth settings, please refer to the barcode reader User Manual.
Check the box
to activate
Baracoda
Header
Check the boxes
to activate
prefix/suffix
Check the box to
Activate no data loss
mode
(acknowledgement)
When Prefix/Suffix
box is checked,
select Data format
(ASCII or Hex)
and type values in
active fields.
Configure the number
of barcodes (0 or
MAX) that are
buffered by the
reader (real time
mode, reading
barcodes while
disconnected)
Check the box
to activate
beep when a
barcode is
decoded
Select beep
volume (high or
low)
Check the box to
activate PIN code
authentication
Select the duration
of Sniff period
Reader’s PIN code,
used when Security
is enabled
Check the box
to activate beep
when a barcode
is acknowledged
by the host PC
(when No data
loss mode is
active)
Select to activate aiming
trigger mode of the scan
engine
Select to
activate
trigger mode
of the scan
engine
(default)
Check the box
to activate
timestamp
(supported on
D-Fly with P/N
“B401202xx”
( firmware >=
v1.54))
Select to
allow
duplicate
scans
Select to disable
duplicate scans
(duplicates not
decoded by the
reader)
Select to disable
duplicate scans
(error beep when
a duplicate
barcode is read)
Select to
activate
manual
autoscan
mode of the
scan engine