Baracoda Bluetooth Headset - Manual (Page 39)

BaracodaManager for PC – User Guide v3.39 - 39 -
Data Capture
for Workforce
in Motion
10.5. Signature/image configuration settings
This configuration window allows the user to set up the signature and picture mode options.
Please note that the signature and image modes are only available for
RoadRunners Evolution 2D readers with firmware versions 1.47 and newer.
The format of the image filename will be the following:
AAA_Filename_BBB_CCC.jpg, where
AAA – reader Bluetooth address (if the “Add reader Bluetooth address to filename” option is
selected). This setting also applies to batch mode.
Filename – specified in the “Filename” text field
BBB – PC timestamp (if the “Add PC timestamp to filename” is selected). The timestamp format is
YYMMDDHHMMSS.
CCC – reader timestamp (if the timestamp has been activated on the reader).
Enable
signature mode
Reference
barcode – a
barcode with
this text will
launch signature
capture
X offset
between the
middle of the
reference
barcode and the
capture area
Y offset
between the
middle of the
reference
barcode and the
capture area
Ratio of the
barcode
height to the
narrow
element width
Width of the
signature
capture area
Height of the
signature
capture area
Number of pixels
that the reader
outputs per each
minimum bar
width
Number of bits
per pixel in the
signature image
Image format
(JPEG
recommended)
Image file options