Baracoda Bluetooth Headset - Manual (Page 62)

BaracodaManager for PC – User Guide v3.39 - 62 -
Data Capture
for Workforce
in Motion
The following table shows the Other Settings buttons that you can set:
Button Functionality
Product Access product settings (see below)
Bluetooth Access Bluetooth connection settings (see below)
Symbology Access types of barcodes settings (see below)
The table below shows the actions you can take with the buttons:
Button Functionality
Cancel Close window with no changes.
Save Store and send the new parameters to the barcode reader.
Default Settings Restore the factory settings. The barcode reader (flash) memory is erased and
the factory default parameters are restored. Check the device manual for
details.
Upgrade Ugrade the reader’s firmware. Please check Chapter 16 for details.
15.1. Product settings
To find out more about the product settings, please refer to the barcode reader User Manual.
Check the box
to activate
Baracoda
Header
Fill in text to
activate
prefix/suffix
Check the box to
Activate no data loss
mode
(acknowledgement)
When Prefix/Suffix
box is checked,
select Data format
(ASCII or Hex)
and type values in
active fields.
Configure the number
of barcodes (0 or
MAX) that are
buffered by the
reader (real time
mode, reading
barcodes while
disconnected). Not
available yet.
Check the box
to activate
beep when a
barcode is
decoded
Select to
activate
reader
vibration
Select to set the
reading mode of
the scan engine
(default trigger)
Check the box to
activate beep when
a barcode is
acknowledged by
the host PC (when
No data loss mode is
active)
Select to set the trigger level of
wrist motion necessary to launch
an automatic scan
Select to set the no
duplicate mode of the
reader (by default
duplicates are allowed)