AEM 30-6905 Universal Programmable EMS-4 - Manual (Page 252)

Page 252 of 279 EMS-4 Install and Tuning Guide_Rev 1.6
Nitrous Control
There are several ways to control nitrous oxide with the AEM EMS. The user has complete
control over all of the nitrous functions, when it activates and deactivates the solenoids, and
how much fuel and timing trims are added. Below is a diagram ofhow AEM recommends wiring
a nitrous setup.
User Definable Options for Nitrous
Nitrous Control
Units: On/Off Desciption: This option enables the nitrous control. Set this to ON to allow the
nitrous control to become active.
N2O Input
Units: Switch Input Desciption: This sets the input request for nitrous to become active under
the setconditions.
N2O Output
Units: User Definable OutputDesciption: This sets the output which activates the relay for the
nitrous control solenoid.