AEM Infinity Supported Applications - Ford Coyote Engine with Ford Racing Control Pack - Manual (Page 32)

32
© 2014 AEM Performance Electronics
Infinity
Pin
Infinity Assignment
Pin
Destination
Ford Coyote with FR
Control Pack
Description
Infinity Hardware
Specification
Notes
C2-18 Analog_In_13 --- Oil Pressure
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out
pins as power supply and Sensor
Ground pins as the low ref erence.
Do not connect signals ref erenced
to +12V as this can permanently
damage the ECU. See Setup
Wizard 'Oil Pressure' page f or
setup options. See OilPressure
[psig] f or channel data.
C2-19 Analog_In_14 ---
Traction Control Mode /
Sensitiv ity
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out
pins as power supply and Sensor
Ground pins as the low ref erence.
Do not connect signals ref erenced
to +12V as this can permanently
damage the ECU. See the
TC_SlipTrgtTrim [MPH] 1-axis
table. A multi-position rotary switch
such as AEM P/N 30-2056 is
recommended.
C2-20 Analog_In_15 --- Exhaust Back Pressure
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out
pins as power supply and Sensor
Ground pins as the low ref erence.
Do not connect signals ref erenced
to +12V as this can permanently
damage the ECU. See Setup
Wizard 'Exhaust Pressure' page f or
setup options. See EBPress [kPa]
f or channel data.
C2-21 Analog_In_16
Engine
E-10
Throttle Position #
Positiv e Slope (TP2)
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out
pins as power supply and Sensor
Ground pins as the low ref erence.
Do not connect signals ref erenced
to +12V as this can permanently
damage the ECU.
C2-22 +5V_Out_2
Ford Racing
PCM70-45
APPVREF (1)
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-23 +5V_Out_2
Ford Racing
PCM70-61
APPVREF (2)
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-24 +5V_Out_2 --- +5V Out
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-25 VR+_In_5 ---
Driv en Right Wheel
Speed Sensor +
Dif f erential Variable
Reluctance Zero Cross
Detection
See Driv en Wheel Speed
Calibration in the Setup Wizard
'Input Function Assignment' page.
C2-26 VR-_In_5 ---
Driv en Right Wheel
Speed Sensor -
C2-27 VR-_In_4 ---
Non Driv en Right Wheel
Speed Sensor -
Dif f erential Variable
Reluctance Zero Cross
Detection
See Non Driv en Wheel Speed
Calibration in the Setup Wizard
'Input Function Assignment' page.
C2-28 V R+_In_4 ---
Non Driv en Right Wheel
Speed Sensor +