Getting started, Loading base session, Infinity connectors – AEM Infinity Supported Applications - Ford Coyote Engine with Ford Racing Control Pack User Manual
Page 5
Infinity Supported Application
5
© 2014 AEM Performance Electronics
GETTING STARTED
Refer to the 10-7100 for EMS 30-7100 Infinity Quick Start Guide for additional information on getting
the engine started with the Infinity EMS.
LOADING BASE SESSION
1.
Connect USB comms cable between ECU and PC.
2.
Turn ignition switch on.
3.
Open InfinityTuner; connection status should be green and indicate ECU type.
4.
Import base session: File>Import Calibration Data. Base sessions are located in C:\Documents
\AEM\Infinity Tuner\Sessions\Base Sessions.
5.
After comms have been reestablished, review Setup Wizard: Wizards>Setup Wizard.
INFINITY CONNECTORS
The AEM Infinity EMS uses the MX123 Sealed
Connection System from Molex. AEM strongly
recommends that users become familiar with the
proper tools and procedures for working with these
high density connectors before attempting any
modifications. The entire Molex MX123 User
Manual can be downloaded direct from Molex at: