JLG 3246E2 ANSI Parts Manual - Manual (Page 32)

1-26 3120738
SECTION 1 FRAME
S
E
C
T
I
O
N
1
F
R
A
M
E
605 4460248 Terminal (Not Shown) 2
606 4751000 Flatwasher #10 2
DRIVE SPEED SWITCH INSTALLATION
(1532E2 & 1932E2 ONLY) Ref.
0270502 1532E2 Ref. C
0258014 1932E2 Ref. J
701 to 716 Not Used
717 0641405 Bolt 1/4”-20NC x 5/8” 2
718 to 750 Not Used
751 4460662 Connector, Strain Relief 1
718 to 754 Not Used
755 4711400 Washer 1/4”, Narrow 6
756 to 764 Not Used
765 0641406 Bolt 1/4”-20NC x 3/4” (S/N 50027 to Present) 4
766 3311405 Locknut 1/4”-20NC 6
767 3570991 Plate, Cover 1
768 3911024 Screw #10-24NC x 1 1/2” 2
769 4360401 Switch, Limit 1
770 3311005 Locknut #10-24NC 2
771 4751000 Washer #10, Wide 2
772 0902501 Bracket, Limit Switch 1
DRIVE SPEED SWITCH INSTALLATION (3246E2 ONLY)
(REFERENCE LETTER “C” ON ART) Ref.
Note: See Section 10 for Japanese Taiyo Spec Ref.
0258889 Standard Control Machines Ref. L
0259408 Proportional Control Machines Ref. H
801 to 819 Not Used
820 0641405 Bolt 1/4”-20NC x 5/8” 4
821 to 837 Not Used
838 3311005 Locknut #10-24NC 2
839 to 858 Not Used
859 4460662 Connector, Strain Relief 1
860 to 862 Not Used
863 4711400 Flatwasher 1/4” Narrow 8
864 to 871 Not Used
872 0902537 Bracket 1
873 3311405 Locknut 1/4”-20NC 4
874 3911024 Screw, Round Head #10-24NC x 3” 2
875 4360401 Switch, Limit 1
876 4751000 Flatwasher #10 8
877 Harness, Elevation Options:
(Not Shown - See Section 7 for Breakdown) A/R
Not Required Standard Controls Machines
4922305 Proportional Control Machines
FIGURE 1-7. FRAME MOUNTED COMPONENTS INSTALLATIONS (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.