JLG 3246E2 ANSI Parts Manual - Manual (Page 92)

3-20 3120738
SECTION 3 SCISSOR ARMS
S
E
C
T
I
O
N
3
S
C
I
S
S
O
R
A
R
M
S
29 Locknut Options: 8
3311505 Locknut 5/16”-18NC (Prior to S/N 52737)
3311605 Locknut 3/8”-16NC (S/N 52737 to Present)
30 Not Used
31 3311505 Locknut 5/16”-18NC 4
32 3422641 Pin, Pivot 2
33 3422642 Pin, Headed 2
34 Pin, Pivot Options: 8
3422644 Prior to S/N 52737
3422746 S/N 52737 to Present
35 Pin, Pivot Options: 14
3422663 Prior to S/N 52737
3422743 S/N 52737 to S/N 82160
3422882 S/N 82160 to Present
36 Pin, Pivot Options: 2
3422671 Prior to S/N 52737
3422742 S/N 52737 to S/N 82160
3422862 S/N 82160 to Present
37 3450804 Pin, Cotter 1/4” x 1” 2
38 3760387 Ring, Retaining 8
39 3841344 Rod, Retaining 2
40 Roller Options: 2
3860078 Prior to S/N 82160
3860092 S/N 82160 to Present
41 3930820 Screw #8-32NC x 1 1/4” 2
42 4240125 Strap, Nylon 4
43 4240128 Strap, Safety Prop 2
44 4360548 Switch, Limit (was p/n 4360321) 1
45 4420062 Tape, UHMW .38ft/
11.6cm
46 to 48 Not Used
49 4740438 Washer, Special 8
50 to 51 Not Used
52 4845574 Prop, Safety 1
53 0641606 Bolt 3/8”-16NC x 3/4” (Prior to S/N 111642) 8
54 3311501 Nut 5/16”-18NC 8
55 1060680 Cable, Electrical - 18/2 17ft/5.2m
56 Connector, Strain Relief Options: 1
Use 4460662 1/2” Pipe Threads (Was P/N 4460049)
4460662 1/2” Pipe Threads (Used on Limit Switch p/n 4360321)
4460968 M20-1.5 (Used on Limit Switch p/n 4360578)
57 4922088 Harness, Lift Down (Lower)
(Not Shown - See Section 7 for Breakdown) 1
58 4922089 Harness, Lift Down (Upper)
(Not Shown - See Section 7 for Breakdown) 1
59 4740307 Washer, Thrust 8
60 Bushing Options (Part of Item 9): 8
0440226 Prior to S/N 49086
0440229 S/N 49086 to Present
FIGURE 3-5. SCISSOR ARMS INSTALLATION - 2646E2 (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.