JLG 3246E2 ANSI Parts Manual - Manual (Page 84)

3-12 3120738
SECTION 3 SCISSOR ARMS
S
E
C
T
I
O
N
3
S
C
I
S
S
O
R
A
R
M
S
34 Pin, Pivot Options: 6
3422644 Prior to S/N 52737
3422746 S/N 52737 to Present
35 Pin, Pivot Options: 10
3422663 Prior to S/N 52737
3422743 S/N 52737 to S/N 82160
3422882 S/N 82160 to Present
36 Pin, Pivot Options: 2
3422671 Prior to S/N 52737
3422742 S/N 52737 to S/N 82160
3422862 S/N 82160 to Present
37 3450405 Pin, Cotter 1/4” x 1 1/4” (Prior to S/N 52737) 11
38 3450804 Pin, Cotter 1/4” x 1” 2
39 3760387 Ring, Retaining 6
40 3841344 Rod, Retaining 2
41 Roller Options: 2
3860078 Prior to S/N 82160
3860092 S/N 82160 to Present
42 3900329 Screw #8-32NC x 1 1/2” 2
43 4240125 Strap, Nylon 2
44 4240128 Strap, Safety Prop 1
45 4360548 Switch, Limit (was p/n 4360321) 1
46 4420062 Tape, UHMW .38ft/
11.6cm
47 to 48 Not Used
49 4711400 Flatwasher 1/4” Narrow A/R
50 4740438 Washer, Special 6
51 4845519 Prop, Safety 1
52 0100039 Loctite #411 (Not Shown) (Prior to S/N 52737) A/R
53 0641606 Bolt 3/8”-16NC x 3/4” 4
54 4750800 Flatwasher #8 2
55 1060680 Cable, Electrical - 18/2 17ft/5.2m
56 Connector, Strain Relief Options: 1
Use 4460662 1/2” Pipe Threads (Was P/N 4460049)
4460662 1/2” Pipe Threads (Used on Limit Switch p/n 4360321)
4460968 M20-1.5 (Used on Limit Switch p/n 4360578)
57 4922086 Harness, Lift Down (Not Shown - See Section 7 for
Breakdown 1
58 Bearing, Excelite Options (Part of Item 10): 4
0440226 Prior to S/N 49086
0440229 S/N 49086 to Present
59 3311501 Nut 5/16”-18NC 4
60 4740307 Washer, Thrust 4
61 4760800 Lockwasher #8 2
62 Locknut Options: 6
3311505 Locknut 5/16”-18NC (Prior to S/N 52737)
3311605 Locknut 3/8”-16NC (S/N 52737 to Present)
63 3760348 Ring, Retainer (S/N 52737 to Present) 12
64 Not Used
FIGURE 3-3. SCISSOR ARMS INSTALLATION - 2032E2 (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.