JLG T350 Service Manual - Manual (Page 162)

SECTION 6 - JLG CONTROL SYSTEM
6-2 – JLG Lift – 3121198
6.2 TO CONNECT THE JLG CONTROL
SYSTEM ANALYZER
1. Connect the cable supplied with the analyzer, to the
controller module in the ground control box and
connect the remaining end of the cable to the ana-
lyzer.
NOTE: The cable has a four pin connector at each end of
the cable; the cable cannot be connected back-
wards.
2. Power up the Control System by turning the key to
the ground position and pulling the emergency stop
button on.
6.3 USING THE ANALYZER
With the machine power on and the analyzer connected
properly, the analyzer will display the following:
HELP:
PRESS ENTER
At this point, using the RIGHT and LEFT arrow keys, you
can move between the top level menu items. To select a
displayed menu item, press ENTER. To cancel a selected
menu item, press ESC.; then you will be able to scroll
using the right and left arrow keys to select a different
menu item.
The top level menus are as follows:
HELP
DIAGNOSTICS
SYSTEM TEST
ACCESS LEVEL
PERSONALITIES
MACHINE SETUP
CALIBRATIONS (view only)
If you press ENTER, at the HELP: PRESS ENTER display,
and a fault is present, the analyzer display will scroll the
fault across the screen. If there was no fault detected, the
display will read: HELP: EVERYTHING OK. If powered up
at the ground station, the display will read: GROUND OK.