JLG T350 Service Manual - Manual (Page 94)

SECTION 3 - CHASSIS & TURNTABLE
3-58 – JLG Lift – 3121198
Choke Actuator
If a new carburetor is needed, the choke detent must be
removed from the new carburetor in order to make the
choke actuator function freely. Use the following proce-
dure.
1. Remove the choke set from the carburetor by care-
fully opening the slot in the choke shaft to remove
the choke plate and pull the shaft out the top.
2. Carefully file or grind the choke detent away.
3. Replace the choke shaft and choke plate.
Checking Oil Level
1. Make sure the machine is level.
2. Switch the engine off before checking oil level.
3. Remove the valve compartment cover to gain
access to the engine.
4. Remove the dipstick.
5. Wipe the dipstick with non-fibrous, clean cloth.
6. Fully seat the dipstick and remove again.
7. Check the oil level, and if necessary, top the oil level
with an approved grade and type of oil as outlined in
the engine manufacturer’s operator’s manual.