5 network connection (rj45), Industrial pcs mcr5000 – ADS-TEC MCR5000 User Manual
Page 27
Industrial PCs MCR5000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
27
5.4
IEEE1394
F
IREWIRE
4-
PIN CONNECTION
(
WITHOUT POWER
)
The FireWire interface is used for fast data exchange between peripherals, e.g. in
industrial and automotive electronics.
PIN NUMBER
SIGNAL NAME
1
TPB-
2
TPB+
3
TPA-
4
TPA+
Note:
The FireWire interface complies with the IEEE 1394a standard (FireWire 400).
5.5
N
ETWORK CONNECTION
(RJ45)
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100/1000 Mbit standard by using
the Ethernet 10/100BaseT network connector. Specifications of this network topology must
be observed in this case. You can install the drivers required for functioning from the
enclosed service CD, should they not be installed on the device.
PIN NUMBER
SIGNAL NAME
1
TX +
2
TX -
3
RX +
4
NC
5
NC
6
RX -
7
NC
8
NC