9 battery replacement, Attery replacement – ADS-TEC MCR5000 User Manual
Page 35
Industrial PCs MCR5000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
35
9
B
ATTERY REPLACEMENT
Please follow this procedure for replacing the lithium battery inside the device:
Disconnect all cables between the MCR 5000 and its TFT or plasma display.
Warning:
Make sure the power plug has been disconnected before starting disassembly.
O
PENING THE LOCKING PLATE
Open the locking plate by using the supplied set of keys. After that, the locking plate can
completely be unhinged and removed.
R
EMOVING THE INSTALLATION BRACKET
1)
Remove both safety screws connecting the installation adapter with the device.
2)
Push and slide the installation adapter upwards and out of the guide.
Warning:
If a TFT or plasma display has been installed, disassembly should be carried out by
at least two persons. Also make sure, that the TFT or plasma display is sufficiently
supported in order to avoid falling after loosening.