Blue Sea Systems 1801 Vessel Systems Monitor VSM 422 - Manual (Page 33)

ALARM SETUP
61
When an alarm is triggered, the screen will change to an alarm summary
screen displaying the:
Alarm type—AC, DC, State of Charge, Bilge and Tank
Alarm limit—High and Low
Alarm limit value
Sensor reading value
Silence the alarm by pressing QUIET. The summary screen will remain vis-
ible until CLOSE is pressed.
Note: When AC is disconnected, alarms for frequency and low voltage will
sound if these alarms are set. Press the QUIET and CLOSE buttons
to silence these alarms. The alarms will not become active again until power
is restored and within limits. If starting a new power source such as a
generator or inverter, check the readings to see that they are within limits
and that the alarm is returned to normal.
A flashing icon representing the alarm type will be displayed in the upper
left-hand corner of all screens. This icon remains in this location until the
problem is resolved.
The label for the value that has been triggered will also flash in all screens
where it is normally shown.
Alarm Icons:
Tank
DC
AC
State of Charge
Bilge
Specifications subject to change. See www.bluesea.com for current information. 62 Specifications subject to change. See www.bluesea.com for current information.