Caution – Elkhart Brass Sidewinder 7100 EXM Monitor User Manual
Page 10
10
Installation Step 1: Mount and Wire All System Components
Installation instructions have been included for all EXM components.
Monitor –
Before mounting the
monitor, ensure that space allows for monitor to
be rotated and calibrated. Disconnect all electrical connections.
Thread monitor onto male 2.5” NPT thread using Loctite 592 or equivalent thread sealant.
Tighten using a strap wrench on the hex portion of the monitor base.
If the monitor will use a CAN line to communicate with other EXM components, connect plug 1
leads to the appropriate CAN line leads.
o
If the monitor will use RF (radio frequency) to communicate with other EXM components,
no preparations are required. The monitor is already RF enabled.
o
If the CAN leads will not be used, replace wires with appropriate plugs.
Supply power to the monitor by connecting the red and black leads from the 6 pin connector to
an appropriate power source. Install a 20 Amp fuse into the positive power lead for a 12V
system (10 Amp for 24V system) to protect the monitor electrical components.
Refer to the respective plug figures for information on the plugs’ pins.
Caution:
Do NOT use motors or discharge as leverage to tighten monitor.
1
2
1
2