Elkhart Brass Sidewinder 7100 EXM Monitor User Manual
Page 29
29
o
The close LED will flash while the valve is closing whether in auto-travel mode or while
holding the CLOSE button. The CLOSE button LED will stay lit while the valve is in the closed
position unless the user brings the system into Setup or Programming Modes.
o
The preset LED will flash after the PRESET button has been pressed and will continue to flash
until the preset destination is reached. The PRESET button LED will stay lit while the valve is in
the PRESET position unless the user brings the system into Setup or Programming Modes.
o
While any monitor/valve command button is being pressed on the Panel Mount or Handheld
Controllers, the blue power LED will flash rapidly in the upper left corner of the controller.
o
When in Setup Mode the yellow status LED in the upper right corner of the Panel Mount and
Handheld controllers will illuminate.
Docking Station LEDs
o
When the Docking Station has power supplied to it and is not charging a Handheld
Controller, the Docking Station LED will be blue and steady.
o
When the Docking Station is charging a Handheld Controller at full capacity, the Docking
Station LED will be red and flashing at a 3 flash per second rate. This will occur if charging a
Handheld whose battery is not near fully charged.
o
When the Docking Station is charging a Handheld Controller in trickle mode, the Docking
Station LED will be green and flashing. This will occur if charging a Handheld whose battery
is almost fully charged.
o
When the Docking Station is housing a Handheld Controller that is fully charged, the Docking
Station LED will be green and steady.
o
If the Docking Station LED is rapidly flashing red (6 flashes per second), this could mean that
the Handheld battery pack of the controller being charged is bad. If this occurs, contact an
Elkhart Brass representative for further instruction.