Elkhart Brass Sidewinder 7100 EXM Monitor - Manual (Page 14)

14
1
2
1
2
Position Feedback Display –
 Using the Position Display template shown in the
Component Mounting Templates section, drill the
two 11/64” holes shown through the panel
intended for mounting the display.
 Mount the Position Feedback Display using two
(2) 6-32 x ½” fasteners secured with blue Loctite
242 or equivalent. Torque to 50-60 in-lbs.
 Connect plug 2 leads to the appropriate CAN
line.
 Supply power to the Position Feedback Display by
connecting plug 1 leads to an appropriate power
source.
 Install a 1 Amp fuse into the positive power lead
of the Position Feedback Display for a 12V system
(1/2 Amp for 24V system).
 Refer to the respective figures for information on
the plugs’ pins.
Important:
Ensure horizontal & vertical calibration is correct or display may not
accurately show position. See Installation Step 3: Calibrate the EXM System.
External RF Antenna Module –
 Remove the OEM Interface Module cover and
connect its antenna wire (under cover) to the round,
white connection on the RF Transceiver Module.
Replace the OEM cover.
 Remove the protective cover from the antenna mount
on the OEM cover and install & tighten the end of
the antenna harness without the antenna onto the
coax connector.
 Locate a suitable mounting surface that provides the
most unobstructed line of sight to the monitor’s
antenna. Drill a ¼” hole in a suitable mounting
surface for the antenna. Unscrew the antenna from
the harness and use its lock washer and nut to attach
the antenna mount to the hole.