Elkhart Brass Sidewinder 7100 EXM Monitor - Manual (Page 21)

21
OPERATING INSTRUCTIONS
To view a demonstration of some operating commands go to
www.elkhartbrass.com to download the
appropriate EXM System Instructional Videos.
A. Button / Joystick Operation
 STREAM – Moves the nozzle in order to
flow a straight stream of water
(Roll thumbwheel forward on the Joystick)
 FOG – Moves the nozzle in order to flow
a fine mist of water
(Roll thumbwheel backward on the
Joystick)
 UP – Moves the monitor in the upward
direction
(Pull the Joystick handle back)
 DOWN – moves the monitor in the
downward direction
(Push the Joystick forward)
 RIGHT – moves the monitor to the right
(Pull the Joystick to the right)
 LEFT – moves the monitor to the left
(Pull the Joystick to the left)
 OSC (OSCILLATE) – Used to set automatic
motion of the monitor
(See step I, Oscillation for directions)
 AUX (AUXILIARY) – Used for various
operations including light operation, etc.
(See step L, Auxiliary for directions)
 CLOSE – Closes the electric valve within the
EXM system
(See step K, Valve Operation for directions)
 PRESET – Opens the electric valve to a
specified position set by the user
(See step K, Valve Operation for directions)
 OPEN – Opens the electric valve within the
EXM system
(See step K, Valve Operation for directions)
 TRIGGER (Joystick) – Opens valve when
pulled. When released, valve will close.
B. Setup Mode
Before some system commands can be entered into the EXM system, the system must be put into Setup
Mode. To bring the system into Setup Mode press and hold the FOG and STREAM buttons
simultaneously for 5 seconds (On the joystick use the PRESET and AUX buttons).
NOTE: Changes made in setup mode will not take effect until after exiting setup mode.
Please refer back to Step 3 in the Installation Instructions section for directions of how to enter and exit
Setup Mode.
Caution:
There are no travel limits when in Setup Mode. MOVE THE MONITOR WITH
CAUTION WHILE IN THIS MODE. Be careful not to move the monitor into obstructions or
itself as this will cause the motors to over current. The monitor may need to be manually
reversed if this occurs.