1 motor power, Motor power – ElmoMC Gold Line Digital Servo Drives-Gold Bassoon User Manual
Page 26
Gold Bassoon Installation Guide
MAN-G-BASIG-EC (Ver. 1.002)
|Motor Power Connector Pinouts
26
Figure 10: Brushless Motor Power Connection Diagram
Figure 11: DC Brushed Motor Power Connection Diagram
6.2.1 Motor Power
To power the drive, connect the M1, M2, M3, and PE pins on the Gold Bassoon. The phase
connection is arbitrary as Elmo Application Studio (EASII) will establish the proper commutation
automatically during setup. When tuning a number of drives, you can copy the setup file to the
other drives and thus avoid tuning each drive separately. In this case the motor-phase order must
be the same as on the first drive.
•
For best immunity, it is highly recommended to use a 4-wire shielded (not twisted) cable for
the motor connection. The gauge is determined by the actual current consumption of the
motor.
•
Connect the cable shield to the closest ground connection at the motor end.
•
For better EMI performance, the shield should be connected to Protective Earth (PE
terminal). Connect the Braid wire to the PE terminal on the motor connector.
•
Ensure that the motor chassis is properly grounded.