ETC Source Four HID - Manual (Page 6)

6 • Source Four™ HID
Cleaning the reflector
To quickly clean the reflector, remove the lens tube and clean the dust from the reflector
with a blast of oil-free air. You may also wipe the reflector with a clean lint-free cloth. If
either method is not sufficient, follow the instructions below. You will need a Phillips
screwdriver to complete this procedure.
1. Remove the barrel rotation knob located at the bottom of the barrel. Use a
Phillips screwdriver to remove the retainer bolt located on top of the reflector
housing.
2. Rotate the barrel 45° in either direction. Carefully remove the barrel from the
reflector housing.
3. Dampen a clean lint-free cloth with alcohol or distilled water. (Alcohol is
recommended.)
4. Gently wipe the reflector.
5. Insert the barrel into the reflector housing with the iris/pattern slot on top. (Line
up the triangles on both parts.)
6. While pressing in gently, rotate the barrel 45° clockwise until it sets into position.
Then, rotate the barrel counterclockwise 45°. The barrel should be firmly
attached and the triangles should line up again.
7. Replace the barrel rotation knob and tighten the retainer bolt.
WARNING! Disconnect the power to the fixture before attempting to clean the reflector.