Bosch VIDEOJET X20 - Manual (Page 118)

118 en | Appendix VideoJet X20
V3.5 | 2007.12 Installation and Operating Manual Bosch Security Systems
8.8.4 Assigning an IP Address
To use a VideoJet X20 in your network, you must assign it an IP address that is valid for your
network.
The following default address is preset at the factory: 192.168.0.1
1. Start a terminal program such as HyperTerminal.
2. Enter the user name service. The terminal program displays the main menu.
3. Enter command 1 to open the IP menu.
4. Enter 1 again. The terminal program displays the current IP address and prompts you to
enter a new IP address.
5. Enter the desired IP address and press Enter. The terminal program displays the new IP
address.
6. Use the displayed commands for any additional settings which you require.
8.8.5 Reboot
Briefly interrupt the power supply to the VideoJet X20 for a reboot (disconnect the power
supply unit from the mains supply and switch on again after a few seconds).
8.8.6 Additional Parameters
You can use the terminal program to check other basic parameters and modify them where
necessary. Use the on-screen commands in the various submenus to do this.
i
NOTICE!
You must reboot to activate the new IP address, a new subnet mask or a gateway address.