Bosch VIDEOJET X20 - Manual (Page 78)

78 en | Configuration Using a Web Browser VideoJet X20
V3.5 | 2007.12 Installation and Operating Manual Bosch Security Systems
5.28.7 HTTPS browser port
If you wish to allow browser access on the network via a secure connection, select an HTTPS
browser port from the list if necessary. The default HTTPS port is 443. Select the Off option to
deactivate HTTPS ports; only unsecured connections will now be possible.
The VideoJet X20 uses the TLS 1.0 encryption protocol.You may have to activate this protocol
via your browser configuration. You must also activate the protocol for the Java applications
(via the Java control panel in the Windows control panel).
You can activate and configure encryption of the media data (video, audio and metadata) on
the Encryption page (see Section 5.30 Encryption, page 82).
5.28.8 RCP+ port 1756
To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want
connection data to be transmitted only when encrypted, select the Off option to deactivate
the port.
5.28.9 Telnet support
If you want to allow only secure connections with encrypted data transmission, you must
select the Off option to deactivate Telnet support. The unit will then no longer be accessible
using the Telnet protocol.
5.28.10 Ethernet link type 1
If necessary, select the Ethernet link type for interface ETH 1. Depending on the unit
connected, it may be necessary to select a special operation type.
5.28.11 Ethernet link type 2
If necessary, select the Ethernet link type for interface ETH 2. Depending on the unit
connected, it may be necessary to select a special operation type.
5.28.12 Network MSS (Byte)
You can set the maximum segment size for the IP packet's user data. This gives you the option
to adjust the size of the data packets to the network environment and to optimize data
transmission. Please comply with the MTU value of 1,514 bytes in UDP mode.
5.28.13 iSCSI MSS (Byte)
You can specify a higher MSS value for a connection to the iSCSI system than for the other
data traffic via the network. The potential value depends on the network structure. A higher
value is only useful if the iSCSI system is located in the same subnet as the VideoJet X20.
i
NOTICE!
If you want to allow only secure connections with SSL encryption, you must select the Off
option for each of the parameters HTTP browser port, RCP+ port 1756 and Telnet support.
This deactivates all unsecured connections. Connections will then only be possible via the
HTTPS port.