Bosch VIDEOJET X20 - Manual (Page 49)

VideoJet X20 Configuration Using a Web Browser | en 49
Bosch Security Systems Installation and Operating Manual V3.5 | 2007.12
5.17.2 iSCSI LUN Map
The LUN map displays the logical drives configured for the iSCSI system. The current user is
displayed for each drive.
1. Double-click a free drive (LUN). The associated information is called up and automatically
displayed in the fields below the map.
2. If the logical drive is password protected, you must first enter the password in the Target
password field and click the Set button.
In cases where the information cannot be read due to the network topology, you must enter
the data manually, so that the VideoJet X20 can access the drive. In this case you should
ensure that the entries correspond exactly with the configuration of the iSCSI system.
1. Enter the required data into the corresponding fields.
2. Click the Set button. The VideoJet X20 will now use this data to try and connect to the
required drive.
As soon as a connection has been established, the selected drive is used for recordings.
5.17.3 Target IP address
Enter the IP address of the required iSCSI target here.
5.17.4 Target node
Enter the number of the iSCSI target node.
5.17.5 Target LUN
Enter the LUN of the required drive.
5.17.6 Target password
If the drive is password protected, enter the password.
5.17.7 Initiator name
The initiator name is automatically displayed after a connection has been established.
5.17.8 Initiator extension
Enter the initiator extension. For the sake of clarity, you can enter a name or the existing
extension with a comment, for example "– Camera 2".
i
NOTICE!
You may not enter a new password. This is only possible by configuring the iSCSI system.