Fig. 145. netcom module, Fig. 146. camera terminal, 2 camera settings – EZWatch Pro 4.0 User Manual
Page 111
110
| Page
“How To” Guide
► Note Different PTZ cameras label the two wire communication wires
differently. However, they all are indicating the same connection. The
(+) communication connection on the Netcom module is labeled TX+/
D+ but the connection at the camera location may be labeled as any of
the following: TX+, RS485+, Red+. Likewise, the negative connection on
the Netcom module is labeled TX-/D-, but the related camera connection
could be labeled TX-, RS485-, or Black-.
Fig. 145. Netcom Module
Camera
Terminal
Fig. 146. Camera Terminal
4.5.2 Camera Settings
There are three main settings required for each camera: baud rate, protocol, and camera address. How
to set each setting varies from camera to camera. Please refer to the installation manual included with
your specific camera.