EZWatch Pro 4.0 - Manual (Page 112)

Page | 111 “How To” Guides
Following the instructions included with the camera set the Protocol to “Pelco D”, set the baud rate
to 2400, and set the camera’s two digit address. When addressing the camera, make the camera’s
address the same as the video input on the DVR. For example, for video input 1 address the camera 01.
Connect the two-wire communication wire to the TX+ and TX- terminals on the camera, as shown in
Fig. 147 .
DVR
Twisted 2-Wire Communications Line
RS-485
Camera Camera Camera Camera
RS-485 RS-485 RS-485
To 16 Cameras
or 3000 feet
Netcom
Module
Fig. 147. Connecting cameras to twisted two-wire
communications lines
4.5.3 Software Set Up
■
Step 1
Go to Start > All Programs > EZWatch Pro 4.0 > Main Console.
■
Step 2
Click the Config button on the Main Console. Then click on the PTZ Config tab at the top
of the window.
Basic Setting Advanced Setting
Fig. 148. PTZ Config tab in Setting window