HiRO H50212 - Manual (Page 197)

User’s Guide Configuring your Computers
197
7. Open the Control Panel window, and then double-click the
Network icon.
8. In the Network dialog box, click the Protocols tab.
9. In the Protocols tab, select TCP/IP, and then click
Properties.
10. In the Microsoft TCP/IP Properties dialog box, click the
radio button labeled Obtain an IP address from a DHCP
server.
11. Click OK twice to confirm and save your changes, and then
close the Control Panel.
Assigning static Internet information to your PCs
If you are a typical user, you will not need to assign static
Internet information to your LAN PCs because your ISP
automatically assigns this information for you.
In some cases however, you may want to assign Internet
information to some or all of your PCs directly (often called
“statically”), rather than allowing the Wireless ADSL2+ Router to
assign it. This option may be desirable (but not required) if:
 You have obtained one or more public IP addresses that
you want to always associate with specific computers (for
example, if you are using a computer as a public web
server).
 You maintain different subnets on your LAN (subnets are
described in Appendix B).
Before you begin, you must have the following information
available:
 The IP address and subnet mask of each PC
 The IP address of the default gateway for your LAN. In
most cases, this is the address assigned to the LAN port on
the Wireless ADSL2+ Router. By default, the LAN port is
assigned the IP address 192.168.1.1. (You can change this
number or another number can be assigned by your ISP.
See Addressing for more information.)
 The IP address of your ISP’s Domain Name System (DNS)
server.
On each PC to which you want to assign static information,
follow the instructions relating only to checking for and/or
installing the IP protocol. Once it is installed, continue to follow
the instructions for displaying each of the Internet Protocol
(TCP/IP) properties. Instead of enabling dynamic assignment of
the IP addresses for the computer, DNS server and default
gateway, click the radio buttons that enable you to enter the
information manually.
Note
Your PCs must have IP addresses that place them in the same
subnet as the Wireless ADSL2+ Router’s LAN port. If you manually
assign IP information to all your LAN PCs, you can follow the
instructions in Addressing to change the LAN port IP address
accordingly.