HiRO H50212 - Manual (Page 71)

User’s Guide Configuring your Computers
71
Field Description
Disable Wireless
LAN Interface Enable/Disable the Wireless LAN Interface.
Band Select the appropriate band from the list provided to
correspond with your network setting.
Mode Configure the Wireless LAN Interface to AP or AP +
WDS mode
SSID Specify the network name.
Each Wireless LAN network uses a unique Network
Name to identify the network. This name is called the
Service Set Identifier (SSID). When you set up your
wireless adapter, you specify the SSID. If you want to
connect to an existing network, you must use the
name for that network. If you are setting up your own
network you can make up your own name and use it
on each computer. The name can be up to 32
characters long and contain letters and numbers.
Channel Width Choose a Channel Width from the pull-down menu.
Control Sideband Choose a Control Sideband from the pull-down menu.
Channel Number Select the appropriate channel from the list provided to
correspond with your network settings. You shall
assign a different channel for each AP to avoid signal
interference.
Radio Power
(mW) The maximum output power: 15mW, 30mW or 60mW.
Function Button Description
Associated
Clients Show Active Wireless Client Table
This table shows the MAC address, transmission,
reception packet counters and encrypted status for
each associated wireless client.
Apply Changes Click to save the rule entry to the configuration.
Reset Discard your changes and reload all settings from flash
memory.