KD Scientific Legato 100 Series User Manual
Page 54
54
Operating the KDS Legato 100 Series
K
D
S
L
e
g
a
to
1
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 100 Series Syringe Pump User’s Manual
Publication 5617-006 Rev D
VERSION
Displays the full version string.
Command format:
version
Query response:
<lf>[##:]Firmware: v#.#.#<cr>
<lf>[##:]Pump address: #<cr>
<lf>[##:]Serial number: C ######<cr>
<lf>[##:]Device ID: ########<cr>
<lf>[##]<prompt>
Run commands
IRUN
Runs the pump in the infuse direction. Configuration Run
screen mode only.
Command format:
irun
RRUN
Runs the pump in the opposite direction. Configuration
Run screen only.
Command format:
rrun
RUN
Simulates a key press of the run button located in the lower
right corner of the screen.
Command format:
run
STOP / STP
Stops the pump.
Command formats:
stop
stp
WRUN
Runs the pump in the withdraw direction. Configuration
Run screen mode only.
Command format:
wrun
Rate commands
CRATE
Displays the current rate that the motor is running at. A
valid response is returned only in dynamic situations (if
the motor is running). Configuration Run screen mode
only.
Command format:
crate
Query response:
<lf>[##:]Infusing at # xl/xxx<cr>
<lf>[##]<prompt>
or:
<lf>[##:]Withdrawing at # xl/xxx<cr>
<lf>[##]<prompt>
DIAMETER
Sets or displays the syringe diameter in mm.
Configuration Run screen mode only.
Command format:
diameter [{syringe diameter}]
Query response:
<lf>[##:]#.#### mm<cr>
<lf>[##]<prompt>
IRAMP
Sets or displays the infusion rates while ramping.
Configuration Run screen mode only.
Command format:
iramp [{start rate} {start units} {end rate} {end units}
{ramp time in seconds}]
Query response:
<lf>[##:]Ramp not set up.<cr>
<lf>[##]<prompt>
or:
<lf>[##:]# xl/xxx to xl/xxx in # seconds<cr>
<lf>[##]<prompt>
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com