MacDon DWA for M Series - Manual (Page 13)

SET UP INSTRUCTIONS
169216 Revision E 11
Deck Installation
To install the DWA deck, follow these steps:
1. Remove 2X4’s (A) by removing banding (B)
and discard.
2. Support deck with fork lift. Forks should be
inboard of shipping stand (C). Remove two
shipping stands (C) at front deck by
removing nut (D). Discard shipping stands.
Re-install nut (D) with washer (E). Washers
are supplied in hydraulic kit.
3. Remove shipping stand (F) at rear of deck
by removing two nuts (G) and (H) and
washers (J). Discard shipping stand and
washers. Retain nuts for re-use.
4. Remove shipping stand (K) by removing
wire (L). Discard shipping stand.
5. Position deck on right hand side of
windrower. Deck is now ready to be
assembled to the linkage underneath the
windrower.
K
L
A
B
B
A
D
C
Fork lift
E
F
G
J
H