MacDon DWA for M Series - Manual (Page 24)

OPERATION
169216 Revision E 22
Side delivery draper speed
To set the draper speed, turn the draper speed
control. (Knob not exactly as shown.)
To adjust deck angle
The deck angle relative to the right hand drive
tire is adjustable with turnbuckle (Q). A distance
of 4 in. (100 mm) from the deck to the tire is
recommended. To adjust the turnbuckle, loosen
the locking tab and rotate center tube to desired
length then relock tab against tube.
NOTE: If setup with an R80 header, the deck
will only be in its most forward position when the
windrower is running. The lift cylinder is single
acting so it is not pressurized in the down stroke
when the windrower is shut off. When the
windrower is running there is a supply of low
pressure oil to move the deck forward.
The deck angle relative to the ground should be
horizontal or at a slight incline. Distance (C)
should be equal to or greater than (D). If used
with an R80 header in lighter crop, distance (C)
should be equal to (D). If the crop needs to be
thrown farther, increase distances (C).
To adjust the deck angle, loosen four 3/4 in.
bolts (E), and then loosen nut (F). Adjust draw
bolt by tightening the second nut (F) if you want
to increase distance (C), and loosen nut if you
want to decrease distance (C). Once done
adjusting, tighten nut (F), and then tighten four
bolts (E). The four 3/4 in. bolts must be torqued
to 245 ft-lbf.
E
DECK ANGLE TO GROUND
C
D
DECK ANGLE TO TIRE
Q
R-Series
Disc Header
A-Series Auger
& D-Series Draper
Headers
100 mm or 4”
C
DRAPER SHUT-OFF SWITCH