MacDon DWA for M Series - Manual (Page 21)

SET UP INSTRUCTIONS
169216 Revision E 19
e. M150/M155: Route hose (G) through
slot in frame member and secure with
cable tie (H) provided as shown above.
f. M205: Route extension hose (G) along
side of windrower frame and secure to
existing hoses with cable tie (H)
provided as shown above.
g. M150/M155/M205: Trim hose (G) to
length as follows:
Disc Headers: Leave approximately
7 in. (180 mm) free hose below
windrower frame.
Auger/Draper Headers: Leave
approximately 14 in. (360 mm) free hose
below windrower frame.
2. M200 Only (Cat Engine) :
a. Locate the hydraulic and fuel tank
breather hose (J).
b. Connect extension hose (G) from kit to
existing hose (H) using straight plastic
joiner and two hose clamps at (L) as
shown.
c. Trim hose (G) to proper length as shown
in step 1 g. above.
G
J
L
M200
G
M205
G
H
G
M150/155
H G