MacDon DWA for M Series - Manual (Page 16)

SET UP INSTRUCTIONS
169216 Revision E 14
1. Install #10 ORB X #10 JIC elbow (A) in port
“DWA” on draper drive block. Install #12
ORB X #10 JIC elbow (B) in port “R1”.
2. Install #10 tee (F) to elbow (B) as shown.
Install pressure hose (C), (with blue cable
tie) from top port of draper drive motor to
elbow (A). Install return hose (D) to tee (F).
Install 1/2 in. lift cylinder hose (E) to tee (F).
3. The installation of case drain hose (G)
depends on the windrower model and the
header model and configuration.
See steps 4–9.
4. On M150/M200 Windrower and A-Series
auger header without reverser kit or R-
Series rotary disc header, connect case
drain hose (G) to “T” port on the header
drive block. First connect #12 ORB X #10
JIC elbow (H) to port “T”, then install #10 JIC
X #6 JIC reducer (J) to elbow (H). Finally
install hose (G) to reducer (J).
5. On M150/M200 Windrower and A-Series
auger headers with reverser kit, connect
case drain hose (G) to “T” port on the
header drive block. First connect #12 ORB X
#10 JIC elbow (H) to port “T”, then install
#10 JIC X #10 JIC elbow (U) to elbow (H)
followed by #10 JIC X #6 JIC reducer (J).
Finally install hose (G) to reducer (J). Make
sure hose (G) is not rubbing against any
fittings.
A B
C
G
D
E
C
D
B
A
F
M150/M200 with
A-Series auger &
R-Series disc headers
H
J
G
M150/M200 with
A-Series auger with reverser
Reverser
H
U
J
G