MacDon DWA for M Series User Manual
Page 25
Advertising
OPERATION
169216
Revision
E
23
To adjust deck height
The deck should never touch the ground or
excessive wear could occur to some deck
components. If the deck is too low to the ground,
raise it as follows:
• Lower linkage by fully extending cylinder.
• Move bottom pivot pin to lower position (R).
• This will raise the front of the deck
approximately 4 in. (100 mm).
Draper tracking
Draper tracking needs to be checked when the
draper is first run-up otherwise damage to the
draper can occur. See Draper Adjustment in the
Maintenance/Service section on how to adjust
the tracking.
E
F
R
Advertising