MacDon DWA for M Series - Manual (Page 20)

SET UP INSTRUCTIONS
169216 Revision E 18
10. The program in the windrower monitor
needs to be changed to recognize the DWA.
a. Turn the key on. Press PROGRAM and
SELECT at the same time. Select YES
for windrower Setup. Toggle between
YES and NO by pressing the ARROWS.
b. Scroll through the menu until display
reads “DWA INSTALLED?” and
select YES.
c. Display will then read “SWAP DWA
CONTROLS?”
Choose 1 of the following 2 options:
• If you want to use the REEL
FORE/AFT switch to raise and lower
the DWA, select YES. The display
will then read “DWA AUTO RAISE?”
Select YES. The REEL FORE/AFT
switch will now be used to raise and
lower the DWA and the ROCKER
switch (F) installed earlier will be
used to control reel fore/aft (D60
headers only).
• If you want to use the ROCKER
switch (F) to raise and lower the
DWA, select NO. The ROCKER
switch will be used to raise and
lower the DWA and the REEL
FORE/AFT switch will continue to
be used to control the reel fore/aft.
d. The display will then read “EXIT DWA
MENU?” Select YES. Press PROGRAM
to revert monitor back to operating
mode.
Tank overflow hose extension
installation
The extension hose prevents overflow fluid
dropping onto DWA draper deck.
To install the tank overflow hose extension,
follow these steps:
1. M150/M155/M205 (Models with Cummins
Engine):
a. Locate the hydraulic and fuel tank
overflow hoses (A and B respectively).
b. Pull fuel tank hose (B) out from
clamp (C).
c. Use plastic tee fitting (D) from kit to join
hydraulic and fuel overflow lines. Hose
(B) connects to 3/8 in. tee branch with
smaller gear clamp (E). Hose (A)
connects to 5/8 in. tee branch with
larger gear clamp (F)
d. Attach extension hose (G) from kit to tee
fitting (D) using another larger gear
clamp (F).
B
C
D
E
M150/155/205
A
G
F
F
REEL UP
REEL AFT
REEL FORWARD
REEL DOWN
DWA DOWN
DWA UP
PROGRAM
SELECT
ARROWS