MacDon HC10 for D-Series - Manual (Page 110)

MAINTENANCE
5.8 Maintenance Schedule
The following maintenance schedule is a listing of periodic maintenance procedures, organized by service intervals.
Regular maintenance is the best insurance against early wear and untimely breakdowns. Following this schedule
will increase machine life. For detailed instructions, refer to the specific headings in this manual. Use the lubricant
specified in section
5.4.1 Lubricants, page 90 .
Service Intervals: The recommended service intervals are in hours of operation. Where a service interval is given
in more than one time frame, e.g., "100 hours or Annually", service the machine at whichever interval is reached first.
IMPORTANT
Recommended intervals are for average conditions. Service the machine more often if operated under
adverse conditions (severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given under section 5.1 Preparation for Servicing, page 87 and section
5.2 Recommended Safety Procedures, page 88 .
Table 5.1 Service Intervals
Interval Service
First use Refer to section 4.6 Break-in Period, page 77 .
10 hours or daily Check hydraulic hoses and lines.
50 hours Grease roll shaft bearings.
Grease feed deck drive and idler roller bearings.
100 hours or annually 9 Check roll drive belt tension.
End of season Refer to section 4.10 Storage, page 86 .
9. It is recommended that annual maintenance be done prior to the start of the operating season.
169254
102
Rev. D