MacDon HC10 for D-Series - Manual (Page 47)

UNLOADING AND ASSEMBLY
9. Reconnect the five hydraulic hoses between the
conditioner and the header as follows:
• Small male quick-disconnect from motor to
header (A)
• Large female quick-disconnect from motor to
header (B)
• Small female quick-disconnect from deck to
header (C)
• Small female quick-disconnect from motor to
deck (D)
• Large female quick-disconnect from header to
motor (E)
Figure 3.22
A - Case Drain B - Conditioner Motor Pressure
C - Deck Motor Return D - Deck Motor Pressure
E - Conditioner Motor Return
3.6.2 Installing Conditioner: Windrower Method
To install the conditioner using the windrower method,
follow these steps:
1. Lower header stand to mid-position (A).
Figure 3.23
2. Attach chain (A) to lifting brackets (B) on conditioner
and secure chain to lifting device.
3. Lift off of shipping pallet and set conditioner on ground
in upright position.
Figure 3.24
169254
39
Rev. D